did I brick?

Hi guys - pretty new to this - sorry. I hope someone can help
Got a pogoplug mobile and followed the instructions here http://archlinuxarm.org/platforms/armv5 ... g-series-4

BUT, as I am an idiot, I was not careful and SKIPPED steps

9
$this->bbcode_second_pass_quote('', 'D')ownload and install Arch Linux ARM:
cd alarm
wget http://archlinuxarm.org/os/ArchLinuxARM ... est.tar.gz
tar -xzvf ArchLinuxARM-kirkwood-latest.tar.gz # This will take a long time
rm ArchLinuxARM-kirkwood-latest.tar.gz
sync # Takes a while if you are using a flash drive

[grayman4hire]

No you didn't brick it assuming the uboot installation went okay.

All you need to do is setup the USB drive. Since the Pogoplug Mobile/Series4 doesn't boot back into the default Pogoplug OS with the new uboot (normal), you'll need to setup the USB drive using a linux computer or linux live boot cd.

http://archlinuxarm.org/support/reinstallation

You can also revert - http://archlinuxarm.org/platforms/armv5 ... s-ui-tabs3 and start over

[barond]

Thanks a lot