How do i check and increase my Refresh Rate ?

Hi All

Im very new to the whole archlinux/raspberry pi systems.

How do i go about check what my current refresh rate is ?

How do i then go about increasing it ?

Below is some info to assist with regards to my OS/Rasberry Versions:

$this->bbcode_second_pass_quote('', 'r')oot@cpt-tv04:/# cat /proc/cmdline
dma.dmachans=0x7f35 bcm2708_fb.fbwidth=1920 bcm2708_fb.fbheight=1080 bcm2708.boardrev=0x10 bcm2708.serial=0x49e4bacd smsc95xx.macaddr=B8:27:EB:E4:BA:CD bcm2708_fb.fbswap=1 bcm2708.uart_clock=3000000 bcm2708.disk_led_gpio=47 bcm2708.disk_led_active_low=0 vc_mem.mem_base=0x1ec00000 vc_mem.mem_size=0x20000000 dwc_otg.lpm_enable=0 console=ttyAMA0,115200 console=tty1 root=/dev/mmcblk0p6 rootfstype=ext4 elevator=deadline rootwait
root@cpt-tv04:/#
root@cpt-tv04:/#
root@cpt-tv04:/# cat /proc/cpuinfo
processor : 0
model name : ARMv6-compatible processor rev 7 (v6l)
BogoMIPS : 2.00
Features : half thumb fastmult vfp edsp java tls
CPU implementer : 0x41
CPU architecture: 7
CPU variant : 0x0
CPU part : 0xb76
CPU revision : 7

Hardware : BCM2708
Revision : 0010
Serial : 0000000049e4bacd
root@cpt-tv04:/#
root@cpt-tv04:/#

[crashmaster]

Maybe with 'xrandr' ?
Changes primarily depend on hardware. Manual changes in Linux can be done in 'xorg.conf' but don't ask me for details. I don't believe there is much additional playground for RPi, but take a look at elinux.org for special configuration features.

[LinuxRSA]

Hi Crashmaster

Thanks for your reply, do you perhaps have the full xrandr command do refresh it ?

Im not familliar with these commands.

Also i followed a article to repair this i could not find the xorg.conf' file - i had to create it.

Let me know

Thanks