Hi ,
I am trying to interface or connect Nit6x_1024x600 LVDS display to freescale imx6q nitrogen6x board. Can any body tell me what is the boot-args we have to set for this.
My printenv command output shown below,
$this->bbcode_second_pass_code('', '
bootargs console=ttymxc1,115200 video=mxcfb1:dev=ldb,1024x600M@60,if=RGB666
baudrate=115200
board=nitrogen6x
bootargs=console=ttymxc1,115200 video=mxcfb0:dev=ldb,1024x600M,if=RGB666 vmalloc=400 video=mxcfb1:off fbM
bootargs_base=mxcfb0:dev=ldb,1024x600M@60,if=RGB666
bootcmd=run bootcmd_mmc
bootcmd_mmc=run bootcmd_base ;for disk in 0 1 ; do mmc dev ${disk} ;for fs in fat ext2 ; do ${fs}load mme
bootdelay=1
clearenv=if sf probe || sf probe || sf probe 1 ; then sf erase 0xc0000 0x2000 && echo restored environmei
console=ttymxc1
cpu=6Q
ethact=FEC
ethaddr=00:19:b8:01:18:ed
ethprime=FEC
kernel=uImage
loadaddr=0x10800000
loadsplash=if sf probe ; then sf read ${splashimage} c2000 ${splashsize} ; fi
panel=wsvga-lvds
rd_loadaddr=(0x10800000 + 0x300000)
uboot=u-boot.bin
upgradeu=for dtype in sata mmc ; do for disk in 0 1 ; do ${dtype} dev ${disk} ;for fs in fat ext2 ; do $e
video=mxcfb0:dev=ldb,1024x600M@60,if=RGB666
')
First time Penguin logo will come during boot-up, after nothing is visible in display. Can anybody tell me what is the problem.
Regards,
Ashwath