Hello everyone,
I was recently given a pandaboard and decided to install arch on it.
I followed the instructions found here : https://archlinuxarm.org/platforms/armv7/ti/pandaboard
And also here https://www.digikey.com/eewiki/display/linuxonarm/PandaBoard
Everything is working well but I'm having issues to make the wifi work.
I tried loading the modules manually like so :
$this->bbcode_second_pass_code('', '
insmod /usr/lib/modules/4.19.0-1-ARCH/kernel/net/rfkill/rfkill.ko.gz
insmod /usr/lib/modules/4.19.0-1-ARCH/kernel/net/mac80211/mac80211.ko.gz
insmod /usr/lib/modules/4.19.0-1-ARCH/kernel/net/wireless/cfg80211.ko.gz
insmod /usr/lib/modules/4.19.0-1-ARCH/kernel/drivers/net/wireless/ti/wlcore/wlcore.ko.gz
insmod /usr/lib/modules/4.19.0-1-ARCH/kernel/drivers/net/wireless/ti/wlcore/wlcore_sdio.ko.gz
insmod /usr/lib/modules/4.19.0-1-ARCH/kernel/drivers/net/wireless/ti/wl12xx/wl12xx.ko.gz
')
I found this page but it is for a older kernel that shows which modules to load.
http://omappedia.org/wiki/MAC802.11_based_Wilink#To_enable_WLAN_on_the_Panda_Board_Linux_Kernel_.28.3E.3D_v3.5.29
I'm not sure if i'm loading the right modules because when I try enabling the interface it says that it can't be found :
$this->bbcode_second_pass_code('', '
ifconfig wlan0 up
wlan0: ERROR while getting interface flags: No such device
')
Anyone ever used those boards?
I know its old hardware but any help is appreciated
Thanks