Odroid C2 IR

[tuxx]

Hi all,

does anyone know the name of the module needed in order to enable the IR receiver?

Thank you in advance.


Michael

[tuxx]

dmesg gives me the following:


$this->bbcode_second_pass_code('', '[ 0.000000] NR_IRQS:64 nr_irqs:64 0
[ 1.998724] eth0: PHY ID 001cc916 at 0 IRQ POLL (stmmac-0:00) active
[ 1.998733] eth0: PHY ID 001cc916 at 7 IRQ POLL (stmmac-0:07)
[ 2.000157] IR NEC protocol handler initialized
[ 2.000165] IR RC5(x) protocol handler initialized
[ 2.000173] IR RC6 protocol handler initialized
[ 2.000180] IR JVC protocol handler initialized
[ 2.000186] IR Sony protocol handler initialized
[ 2.000194] IR RC5 (streamzap) protocol handler initialized
[ 2.000201] IR SANYO protocol handler initialized
[ 2.000208] IR MCE Keyboard/mouse protocol handler initialized')

[yassine]

It's 'meson-ir' for the C1 (from the wiki). That may be the same for the C2 as they have the same form factor.
Sorry that's all I know

[tuxx]

It was the first I tried without any luck!

[tuxx]

Unfortunately no luck yet with Hardkernel support.

Their official reply was:

$this->bbcode_second_pass_quote('', 'W')e supported the LIRC on the C1 board. But we didn't try it on C2 yet.
http://odroid.com/dokuwiki/doku.php?id=en:c1_lirc

If the link is not helpful, we will add this request in the to-do list of April.

[tuxx]

Looking at the current kernel config of c2, I see:

$this->bbcode_second_pass_code('', '# CONFIG_LIRC is not set')

Does ArchlinuxARM use official .config file or it's a custom configuration?