RPi-4B 4GB 2018 New install with Aug 2022 aarch64 image will not boot. However, new installs with PIOS 32 or 64, and Arch 32 will. Looks like a SD card problem. Used same card for other tests and tried a new card for last mainline aarch64 test with same result. Interestingly the SD card boots ok on a different RPi-4. Must be a hardware issue with the RPi. serial console (output repeats the block until power off. )
$this->bbcode_second_pass_code('', '
[ 3.471072] raspberrypi-firmware soc:firmware: Attached to firmware from 2022-07-25T15:10:17
[ 3.659865] dwc2 fe980000.usb: supply vusb_d not found, using dummy regulator
[ 3.667252] dwc2 fe980000.usb: supply vusb_a not found, using dummy regulator
[ 3.775074] dwc2 fe980000.usb: EPs: 8, dedicated fifos, 4080 entries in SPRAM
[ 3.828110] xhci_hcd 0000:01:00.0: xHCI Host Controller
[ 3.833523] xhci_hcd 0000:01:00.0: new USB bus registered, assigned bus number 1
[ 3.841296] xhci_hcd 0000:01:00.0: hcc params 0x002841eb hci version 0x100 quirks 0x0000040000000890
[ 3.851168] usb usb1: New USB device found, idVendor=1d6b, idProduct=0002, bcdDevice= 5.18
[ 3.859564] usb usb1: New USB device strings: Mfr=3, Product=2, SerialNumber=1
[ 3.866895] usb usb1: Product: xHCI Host Controller
[ 3.871843] usb usb1: Manufacturer: Linux 5.18.1-1-aarch64-ARCH xhci-hcd
[ 3.878645] usb usb1: SerialNumber: 0000:01:00.0
[ 3.883627] hub 1-0:1.0: USB hub found
[ 3.887482] hub 1-0:1.0: 1 port detected
[ 3.891759] xhci_hcd 0000:01:00.0: xHCI Host Controller
[ 3.897150] xhci_hcd 0000:01:00.0: new USB bus registered, assigned bus number 2
[ 3.904665] xhci_hcd 0000:01:00.0: Host supports USB 3.0 SuperSpeed
[ 3.911171] usb usb2: New USB device found, idVendor=1d6b, idProduct=0003, bcdDevice= 5.18
[ 3.919665] usb usb2: New USB device strings: Mfr=3, Product=2, SerialNumber=1
[ 3.926996] usb usb2: Product: xHCI Host Controller
[ 3.931944] usb usb2: Manufacturer: Linux 5.18.1-1-aarch64-ARCH xhci-hcd
[ 3.938743] usb usb2: SerialNumber: 0000:01:00.0
[ 3.943675] hub 2-0:1.0: USB hub found
[ 3.947530] hub 2-0:1.0: 4 ports detected
[ 3.965682] sdhci-iproc fe300000.mmc: allocated mmc-pwrseq
[ 4.020599] mmc0: SDHCI controller on fe300000.mmc [fe300000.mmc] using PIO
[ 4.067962] ALSA device list:
[ 4.070997] No soundcards found.
[ 4.108699] mmc1: SDHCI controller on fe340000.mmc [fe340000.mmc] using ADMA
[ 4.117083] mmc0: new high speed SDIO card at address 0001
[ 4.120622] Freeing unused kernel memory: 6464K
[ 4.127338] Run /init as init process
[ 4.139882] usb 1-1: new high-speed USB device number 2 using xhci_hcd
[ 4.164843] mmc1: ADMA error: 0x02000000
[ 4.168843] mmc1: sdhci: ============ SDHCI REGISTER DUMP ===========
[ 4.175383] mmc1: sdhci: Sys addr: 0x00000000 | Version: 0x00001002
[ 4.175387] mmc1: sdhci: Blk size: 0x00007008 | Blk cnt: 0x00000001
[ 4.175391] mmc1: sdhci: Argument: 0x00000000 | Trn mode: 0x00000013
[ 4.175394] mmc1: sdhci: Present: 0x1fff0206 | Host ctl: 0x00000011
[ 4.175397] mmc1: sdhci: Power: 0x0000000f | Blk gap: 0x00000080
[ 4.175400] mmc1: sdhci: Wake-up: 0x00000000 | Clock: 0x00007d07
[ 4.175403] mmc1: sdhci: Timeout: 0x00000000 | Int stat: 0x00000000
[ 4.221091] mmc1: sdhci: Int enab: 0x03ff100b | Sig enab: 0x03ff100b
[ 4.221095] mmc1: sdhci: ACmd stat: 0x00000000 | Slot int: 0x00000000
[ 4.221098] mmc1: sdhci: Caps: 0x45ee6432 | Caps_1: 0x0000a525
[ 4.240679] mmc1: sdhci: Cmd: 0x0000333a | Max curr: 0x00080008
[ 4.240682] mmc1: sdhci: Resp[0]: 0x00000920 | Resp[1]: 0x0076b27f
[ 4.240685] mmc1: sdhci: Resp[2]: 0x325b5900 | Resp[3]: 0x00400e00
[ 4.240688] mmc1: sdhci: Host ctl2: 0x00000008
[ 4.264765] mmc1: sdhci: ADMA Err: 0x00000001 | ADMA Ptr: 0xc3000200
[ 4.264767] mmc1: sdhci: ============================================
[ 4.264770] mmc1: sdhci: c3000200: DMA 0xf3400000, LEN 0x0008, Attr=0x21
[ 4.284613] mmc1: sdhci: c3000208: DMA 0x00000000, LEN 0x0000, Attr=0x03
[ 4.284786] mmc1: error -5 whilst initialising SD card
[ 4.306490] usb 1-1: New USB device found, idVendor=2109, idProduct=3431, bcdDevice= 4.21
[ 4.314900] usb 1-1: New USB device strings: Mfr=0, Product=1, SerialNumber=0
[ 4.322155] usb 1-1: Product: USB2.0 Hub
[ 4.329050] hub 1-1:1.0: USB hub found
[ 4.333121] hub 1-1:1.0: 4 ports detected
[ 4.591100] mmc1: ADMA error: 0x02000000
[ 4.595098] mmc1: sdhci: ============ SDHCI REGISTER DUMP ===========
[ 4.601629] mmc1: sdhci: Sys addr: 0x00000000 | Version: 0x00001002
[ 4.608160] mmc1: sdhci: Blk size: 0x00007008 | Blk cnt: 0x00000001
[ 4.614690] mmc1: sdhci: Argument: 0x00000000 | Trn mode: 0x00000013
[ 4.618887] usb 1-1.3: new full-speed USB device number 3 using xhci_hcd
[ 4.621219] mmc1: sdhci: Present: 0x1fff0206 | Host ctl: 0x00000011
[ 4.621223] mmc1: sdhci: Power: 0x0000000f | Blk gap: 0x00000080
[ 4.621226] mmc1: sdhci: Wake-up: 0x00000000 | Clock: 0x0000a707
[ 4.621229] mmc1: sdhci: Timeout: 0x00000000 | Int stat: 0x00000000
[ 4.621231] mmc1: sdhci: Int enab: 0x03ff100b | Sig enab: 0x03ff100b
[ 4.621234] mmc1: sdhci: ACmd stat: 0x00000000 | Slot int: 0x00000000
[ 4.621237] mmc1: sdhci: Caps: 0x45ee6432 | Caps_1: 0x0000a525
[ 4.673715] mmc1: sdhci: Cmd: 0x0000333a | Max curr: 0x00080008
[ 4.680243] mmc1: sdhci: Resp[0]: 0x00000920 | Resp[1]: 0x0076b27f
[ 4.686772] mmc1: sdhci: Resp[2]: 0x325b5900 | Resp[3]: 0x00400e00
[ 4.693301] mmc1: sdhci: Host ctl2: 0x00000008
[ 4.697801] mmc1: sdhci: ADMA Err: 0x00000001 | ADMA Ptr: 0xc3000200
[ 4.704328] mmc1: sdhci: ============================================
')