bridge issues

[qlem]

Hi,

After my last system upgrade via pacman on my raspberry pi 3, i have a bridge issue at boot :
$this->bbcode_second_pass_code('', '
[...] bridge: filtering via arp/ip/ip6tables is no longer available by default. Update your scripts to load br_netfilter if you need this.
[...] Bridge firewalling registered
...
')

Then, every short period of time (few seconds), logs about network interface, port, table, state, etc appear in the stdout.

My rpi3 hosts two docker containers on the same virtual network (the bridge is created by docker). These two containers cannot start since this issue appear.

How i can fix this please ?

[graysky]

Are you sure this is related? I have seen that output for months yet my bridge for lxc still works.
$this->bbcode_second_pass_code('', '% dmesg | grep -i bridge
[ +0.000053] brcm-pcie fd500000.pcie: host bridge /scb/pcie@7d500000 ranges:
[ +0.000184] brcm-pcie fd500000.pcie: PCI host bridge to bus 0000:00
[ +0.000027] pci 0000:00:00.0: bridge configuration invalid ([bus 00-00]), reconfiguring
[ +0.000041] pci 0000:00:00.0: PCI bridge to [bus 01]
[ +0.000025] pci 0000:00:00.0: bridge window [mem 0x600000000-0x6000fffff]
[ +0.620472] bridge: filtering via arp/ip/ip6tables is no longer available by default. Update your scripts to load br_netfilter if you need this.
')

[qlem]

I do not have lots of knowledge about network but yes, i think is related. I misspoke, the containers start well but the mapping of the ports between the host and the service is missing. Moreover, as I said, there are lots of logs about network that appear every short time period on the stdout.