Hello friends,
I followed the install instructions on the wiki: https://archlinuxarm.org/platforms/armv8/amlogic/odroid-c2
My ODROID-C2 boots and sets the selected video mode in boot.ini on my monitor via HDMI successfully but then doesn't appear to actually write anything to the screen, nor does ethernet appear to grab DHCP (I see no DHCP requests in my router logs). The screen remains blank - not even a cursor.
I hooked up UART and pulled the the attached log. I have pored over the log but I cannot find anything that indicates what might be wrong. If I replug the HDMI or add a USB device, I see related messages appear on UART, and the blue kernel light flashes, so it appears to be running fine and not frozen. I cannot send commands via UART, not sure if that is normal?
I tried a few different video modes and another monitor (actually a TV) but no luck, same issue.
Can anyone advise how I can troubleshoot this further? Thank you.