CubieBoard 2.0 Archlinux does not set hdmi correctly

Development on core packages and the distribution goes on in here.

CubieBoard 2.0 Archlinux does not set hdmi correctly

Postby klankschap » Thu Sep 12, 2013 3:40 pm

Just installed the ArchLinux distro on a microSD for the CubieBoard 2.0
After powerup i get a message on my hdmi monitor that the scan freq are out of range.
When i change monitor, i get 720P info and TWO screens on a single display.

How can i adjust the settings on the CB2 ArchLinux so that it will recognize the attached monitors correctly?

Thanks
.F
klankschap
 
Posts: 5
Joined: Wed Jul 31, 2013 7:49 pm

Return to Arch Linux ARM

Who is online

Users browsing this forum: No registered users and 5 guests