by Aarshad » Mon Jul 18, 2011 9:00 am
$this->bbcode_second_pass_quote('WarheadsSE', 'T')hat link's directions are beyond ANCIENT, and for "ARCH LEENUCKS ARM!1ONE" NOT Full blown Arch Linux ARM linux.
Our current wiki contains the proper directions, which weren't followed. Get a serial cable, and hope.
As over the chat through IRC channels, the plug wont boot to the stock pogoplug, we thought that the rcS might be corrupted or deleted, but since the bootloader was on the plug and working, after putting an root fs on an USB I managed to install the Arch Linux ARM and mounted the orginal POGO device with $this->bbcode_second_pass_code('', 'mount -t jffs2 /dev/mtblock2 /dev/pogo').
so i went and had a look and it looks fine, I dont get it now, is their a reason that when i pull the USB out that the pogoplug wont boot to its stock rootfs but the LED keeps blinking ?.
$this->bbcode_second_pass_code('', '#! /bin/sh
mount -t proc none /proc
mount -t sysfs none /sys
mount -t devpts none /dev/pts
mount -t tmpfs none /tmp
mount -t usbfs none /proc/bus/usb
mkdir /tmp/var
echo "/tmp/core_%e_%t" > /proc/sys/kernel/core_pattern
hostname Pogoplug
ifconfig lo 127.0.0.1
ifconfig eth0 169.254.37.133
udhcpc -b `hostname`
#telnetd
/etc/init.d/db
#Uncomment the line below to enable the pogoplug service
#/etc/init.d/hbmgr.sh start
#/bin/mount -a')