by technosf » Sat Jun 25, 2011 11:25 pm
Hi Y'all,
At the bottom of the Pogo V2 install page it says:
$this->bbcode_second_pass_quote('', '
')Can I use ext3/4?
U-Boot only supports booting from ext2 drives. Booting from ext3/4 drives is unstable and is not recommended. But, if you know what you're doing, you can make an ext2 /boot partition as sda1 and partition the rest as ext3/4. Make sure to edit /etc/fstab too!
Yes... I'd like to do that!
I have a SSD with three partitions, SDA1..3. SDA1 is ext2, SDA2 is swap and SDA3 is ext2 (to be upgraded to ext4 later). I want to put make SDA1
/boot and SDA3
/ (root). I have dumped the whole rootfs into SDA3 and it'll boot, where I get stuck is after putting the image on SDA1, getting SDA3 recognized as root.
Are there more in-depth instructions? Anyone done this - how to get set the mountpoints correctly?
Cheers.