Hi,
I am trying to install Arch ARM on Raspberry Pi using following guide. However in point about mkinitcpio.conf there is a need to add netconf module, which caused following warnings:
$this->bbcode_second_pass_code('', '
==> WARNING: Possibly missing firmware for module: rtl8723ae
==> WARNING: Possibly missing firmware for module: b43legacy
==> WARNING: Possibly missing firmware for module: b43
==> WARNING: Possibly missing firmware for module: p54usb
==> WARNING: Possibly missing firmware for module: p54pci
==> WARNING: Possibly missing firmware for module: prism54
==> WARNING: Possibly missing firmware for module: orinoco_usb
==> WARNING: Possibly missing firmware for module: ipw2100
==> WARNING: Possibly missing firmware for module: ipw2200
==> WARNING: Possibly missing firmware for module: rsi_sdio
==> WARNING: Possibly missing firmware for module: rsi_usb
==> WARNING: Possibly missing firmware for module: wcn36xx
==> WARNING: Possibly missing firmware for module: zd1211rw
==> WARNING: Possibly missing firmware for module: zd1201
==> WARNING: Possibly missing firmware for module: mt7603e
==> WARNING: Possibly missing firmware for module: at76c50x_usb
==> WARNING: Possibly missing firmware for module: atmel
')
and the resulting image when booted waits for wlan0 for 90 seconds, then gave up and network is not available.
When I recreate the boot images with empty hooks, then the network is working correctly. How should I fix this issue? Should I install all missing firmwares or block them somehow?
I used the following image for this: ArchLinuxARM-rpi-aarch64-latest.tar.gz
Regards,
Zaxon