I finally got around to trying this, and i followed the steps exactly (twice even) and this is the error i get from the serial console. Any ideas? Thanks.
$this->bbcode_second_pass_code('', '
Stage-1 Bootloader Mon Nov 14 22:36:34 EST 2011
Attempting to set PLLA to 850MHz ...
plla_ctrl0 : 0x0000020A
plla_ctrl1 : 0x00330000
plla_ctrl2 : 0x0065008B
plla_ctrl3 : 0x000000F1
PLLA Set
Setup memory, testing
Reading disk 0, Image 0
Sector : 0x0000009A
Hdr len: 0x0001FB34
Hdr CRC: 0x2229BDCD
OK
Initialising disks
SATA PHY not ready for device 1
Detecting SATA busses:
Bus 0: Found first device OK
Device 0: Model: Hitachi HTS545050B9A300 Firm: PB4OC64G Ser#: 090620PB4400Q7H 27VJG
Type: Hard Disk
Capacity: 131071.9 MB = 127.9 GB (268435455 x 512)
Device 1: not available
Failed to read valid environment from disk, using built-in default
U-Boot 1.1.2 (Dec 31 2011 - 15:24:45)
U-Boot code: 60E00000 -> 60E1FB34 BSS: -> 60E5435C
RAM Configuration:
Bank #0: 60000000 128 MB
SRAM Configuration:
64KB at 0x50000000
NAND:128 MiB
*** Warning - bad CRC, using default environment
In: serial
Out: serial
Err: serial
Setting Linux mem= boot arg value
IDE read: device 0 block # 288, count 1 ... 1 blocks read: OK
Hit any key to stop autoboot: 0
Loading from IDE device 0, partition 2: Name: hda2
Type: U-Boot
** Bad Magic Number **
Unknown command 'lightled' - try 'help'
$
')