not able to boot in arch goflex

[moonman]

The trick is to use "usb start; usb stop; usb start;" in bootcmd.

Can you show the output of "fw_printenv | grep bootcmd" when booted into the rescue image.

[nick2012]

$this->bbcode_second_pass_code('', 'rescue:~# fw_printenv | grep bootcmd
rescue_bootcmd=if test $rescue_installed -eq 1; then run rescue_set_bootargs; nand read.e 0x800000 0x100000 0x400000; bootm 0x800000; else run pogo_bootcmd; fi
pogo_bootcmd=if fsload uboot-original-mtd0.kwb; then go 0x800200; fi
force_rescue_bootcmd=if test $force_rescue -eq 1 || ext2load usb 0:1 0x1700000 /rescueme 1 || fatload usb 0:1 0x1700000 /rescueme.txt 1; then run rescue_bootcmd; fi
ubifs_bootcmd=run ubifs_set_bootargs; if ubi part data && ubifsmount rootfs && ubifsload 0x800000 /boot/uImage && ubifsload 0x1100000 /boot/uInitrd; then bootm 0x800000 0x1100000; fi
usb_bootcmd=run usb_init; run usb_set_bootargs; run usb_boot
sata_bootcmd=run sata_set_bootargs; run sata_boot
bootcmd=usb start; run force_rescue_bootcmd; run ubifs_bootcmd; run usb_bootcmd; usb stop; run sata_bootcmd; run rescue_bootcmd; run pogo_bootcmd; reset
')

[nick2012]

btw where to add this??
where is bootcmd located??

[moonman]

the last variable in your last post...

Run this:
$this->bbcode_second_pass_code('', 'fw_setenv bootcmd 'usb start; usb stop; usb start; run force_rescue_bootcmd; run ubifs_bootcmd; run usb_bootcmd; usb stop; run sata_bootcmd; run rescue_bootcmd; run pogo_bootcmd; reset'')

If it doesn't help, check if your hdd/flash drive is not dead

[nick2012]

$this->bbcode_second_pass_quote('moonman', 't')he last variable in your last post...

Run this:
$this->bbcode_second_pass_code('', 'fw_setenv bootcmd 'usb start; usb stop; usb start; run force_rescue_bootcmd; run ubifs_bootcmd; run usb_bootcmd; usb stop; run sata_bootcmd; run rescue_bootcmd; run pogo_bootcmd; reset'')

If it doesn't help, check if your hdd/flash drive is not dead

[moonman]

I would try to reinstall from scratch or use a different harddrive/flash drive. Or even install on the sata drive.

[nick2012]

Ohk reinstalled from scratch and everything is working fine now..
Thanks moonman for help