Hello,
I installed my quad wandboard after this installation routine:
http://archlinuxarm.org/platforms/armv7 ... /wandboard
After the wandboards to boot I get the following message via the RS232 connection to the wandboard:
U-Boot 2013.07 (Jul 25 2013 - 21:06:42) Arch Linux ARM
CPU: Freescale i.MX6Q rev1.2 at 792 MHz
Reset cause: POR
Board: Wandboard
DRAM: 2 GiB
MMC: FSL_SDHC: 0, FSL_SDHC: 1
In: serial
Out: serial
Err: serial
Net: FEC [PRIME]
Hit any key to stop autoboot: 4 3 2 1 0
mmc0 is current device
** Unrecognized filesystem type **
** Unrecognized filesystem type **
Booting from net ...
BOOTP broadcast 1
*** Unhandeld DHCP Option in OFFER/ACK: 42
*** Unhandeld DHCP Option in OFFER/ACK: 42
DHCP client bound to adress 192.168.178.20
Using FEC device
TFTP from server 192.168.178.1; our IP adress is 192.168.178.20
Filename 'uImage'
Load address: 0x12000000
Loading:TTTT...
This routine is repeated continuously.
If I stop using the CTRL C, I get the following message:
Abort
Wrong Image Format for bootm command
ERROR: can not get kernel image!
What am I doing wrong?
regards
kwalter