Hello all,
After some time I wanted to try kernel upgrade, but it failed to boot again. I am still running 3.14.58-1 which boots and works OK..
Trying to boot with 3.14.78-1 I am getting on serial console/HDMI TV only this:
U-Boot SPL 2013.10-rc4 (Nov 05 2015 - 12:59:56)
Boot Device: SD1
spl: error reading image u-boot.img, err - -1
Load image from RAW...
U-Boot 2013.10-rc4 (Nov 05 2015 - 12:59:56)
CPU: Freescale i.MX6Q rev1.5 at 792 MHz
Reset cause: POR
Board: MX6-CuBox-i
DRAM: 3.8 GiB
MMC: FSL_SDHC: 0
*** Warning - bad CRC, using default environment
In: serial
Out: serial
Err: serial
Net: FEC [PRIME]
(Re)start USB...
USB0: USB EHCI 1.00
scanning bus 0 for devices... 1 USB Device(s) found
scanning usb for storage devices... 0 Storage Device(s) found
scanning usb for ethernet devices... 0 Ethernet Device(s) found
Hit any key to stop autoboot: 0
mmc0 is current device
** File not found /boot.scr **
** File not found /uEnv.txt **
** File not found /zImage **
** File not found /uImage **
** File not found /boot/boot.scr **
227 bytes read in 88 ms (2 KiB/s)
Importing environment from mmc0 ...
6986024 bytes read in 656 ms (10.2 MiB/s)
Booting from mmc ...
** File not found /boot/initramfs-linux.img **
Loaded initramfs-linux.img
33907 bytes read in 78 ms (423.8 KiB/s)
Loaded imx6q-cubox-i.dtb
Booting zImage
Kernel image @ 0x10800000 [ 0x000000 - 0x6a9928 ]
## Flattened Device Tree blob at 18000000
Booting using the fdt blob at 0x18000000
Using Device Tree in place at 18000000, end 1800b472
Starting kernel ...
And it end's up there, no further input on serial console, HDMI connected TV just blacks-out. Also ethernet link is not bought up. I guess it just cannot start the kernel.
I have got the same issue when last time tried to upgrade to 3.14.69-1 referenced here: viewtopic.php?f=23&t=10301
Root fs resides on external e-sata ssd disk and after upgrading my system with pacman -Syu I just manually copy contents of /boot to the SD card…
To get system boot again, I just have to replace bzImage with 3.14.58-1 version..
Many thanks for any help, I'm not sure if this is somehow connected to uboot, kernel or anything else...