Hi,
I've installed archlinux on my nsa320, worked fine. After the installation and first boot I can log in through ssh. I've shutted down with shutdown -h, and installed my second hdd in the right slot. It's a 3TB with gpt and 2 linux raid partition.
After switch on, durng boot there was very much hdd access (lasts about 5 minutes). After this finished, I can't log in, the box doesn't asked IP from DHCP server. I dont have ttl serial console now, so I can't see what happens.
I powered off (unplugged the power cord), removed the second hdd, and started the nsa again, but still doesn't asked IP. Hearing the hdd, it loads the kernel (and maybe the initrd), but nothing happens.
OK, i've done the installation process on hdd again as in the usb_key_func.sh and tried again. Same result, after switch on, it loads something (I suspect the kernel and initrd), and stops, nothing happens, can't connect.
Any advice, or I need to check on serial console? I have only 5V ttl usb-serial plug, so I need to wait 'till the 3,3V arrives in 2-3 weeks (ali-express?).
Thanks,
Gergő