by balanga » Thu Nov 02, 2017 9:59 pm
I managed to get this onto my USB stick when it booted up, but even though I set it to executable I couldn't get it to run...
Any clues?
$this->bbcode_second_pass_code('', '
[code]flash_uboot() {
if [[ ! -e /dev/mtd0 ]]; then
echo '>> Error: /dev/mtd0 does not exist.'
return
fi
# set up config for fw_printenv/setenv
echo '/dev/mtd0 0xc0000 0x20000 0x20000' > /etc/fw_env.config
# save MAC address
mac=$(fw_printenv | grep ethaddr | cut -d= -f2)
if [[ $mac == '' ]]; then
echo '>> Error: Could not find MAC address from current U-Boot.'
return
fi
# flash U-Boot
flash_erase /dev/mtd0 0 4
flash_erase /dev/mtd0 0xc0000 1
nandwrite /dev/mtd0 /boot/uboot-goflexhome.kwb
nandwrite -s 0xc0000 /dev/mtd0 /boot/uboot-goflexhome.env
# set MAC address
fw_setenv ethaddr ${mac}
}
ask_uboot() {
echo "A new U-Boot version needs to be flashed to NAND."
echo "Do you want to do this now? [y|N]"
read -r shouldwe
if [[ $shouldwe =~ ^([yY][eE][sS]|[yY])$ ]]; then
flash_uboot
else
echo "You can do this later by re-installing uboot-goflexhome."
fi
}')