Just did my first install on my RP3 B+. I was surprised to see that I already had an IP address and sshd was running.
On a normal install on an x86_64 system I had to start and enable dhcpcd and sshd to get that far. I can see that there is s sshd.service, but I don't see a dhcpcd.service. Who's handing out dhcp address on the ARM version??
Jim A
[Solved]Who turned on dhcpcd?
3 posts
• Page 1 of 1
[Solved]Who turned on dhcpcd?
by jfabernathy » Mon Jan 14, 2019 8:52 pm
Last edited by jfabernathy on Mon Jan 14, 2019 9:08 pm, edited 1 time in total.
- jfabernathy
- Posts: 30
- Joined: Mon Jan 14, 2019 7:36 pm
Re: Who turned on dhcpcd?
by graysky » Mon Jan 14, 2019 8:53 pm
The same thing that's managing your NIC: systemd-networkd
- graysky
- Developer
- Posts: 1731
- Joined: Sun Jun 26, 2011 6:56 am
- Location: /run/user/1000
3 posts
• Page 1 of 1
Who is online
Users browsing this forum: No registered users and 2 guests