no IP after load

[archsrvrs]

Hi there, I have a goFlex Home 3TB. I followed the instructions located at http://archlinuxarm.org/platforms/armv5/seagate-goflex-home. The only deviation I did was pull the drive and format it externally (since it was a 3TB drive). I did GPT, a 40GB SDA1 and the balance on SDA2. So I got as far as doing the halt, and power cycle. Now the unit is powered up, but it is not getting an IP when it is powered up. I do not see any ARP entries on my router for it. I also added the MAC address to a reservation (so that I would know what IP it would come up on). The light on the front is blinking rapidly (green). But I am having no luck. Ideas?

[archsrvrs]

It looks like i am having the same issue as http://archlinuxarm.org/forum/viewtopic.php?f=9&t=3047&p=17613&hilit=goflex+home#p17613. I should take this up in that thread. Sorry for the double post.

[WarheadsSE]

Have you had any luck with netconsole? (advanced tab on device page)