PPv4 Connection Refused and New IP Address/MAC

$this->bbcode_second_pass_quote('UberSlackr', '')$this->bbcode_second_pass_quote('DaCurryman', 'd')on't know what happened. just rebooted the PPv4 with just the USB stick again and then plugged in the GoFlex and it seems to have picked it up. gonna see what I can do with it now.

[moonman]

Booting from USB. Do you have an updated bootloader or the one the instructions on the main page tell you to install. If it's the old one, then your USB stick has to have label "rootfs" and your sata drive has to NOT have that label.

As for the autmounting, udev-automount does not play nice with ntfs since the switch to systemd. Look for suggestions in the announcment thread about autmounting, specifically the last posts.

[DaCurryman]

$this->bbcode_second_pass_quote('moonman', 'B')ooting from USB. Do you have an updated bootloader or the one the instructions on the main page tell you to install. If it's the old one, then your USB stick has to have label "rootfs" and your sata drive has to NOT have that label.

As for the autmounting, udev-automount does not play nice with ntfs since the switch to systemd. Look for suggestions in the announcment thread about autmounting, specifically the last posts.

[WarheadsSE]

The format of the drive when attached to the Pogoplug does not matter to the windows/mac machines since they use it over sshfs.

[DaCurryman]

So if I try to reinstall this thing again (for the 3rd time), are the listed instructions on the below page still good/current?
http://archlinuxarm.org/platforms/armv5 ... s-ui-tabs2

Or is there an updated set of files/instructions I should be using (maybe that's causing my problems)?

Thanks.