uBoot verification failed

This forum is for Marvell Kirkwood devices such as the GoFlex Home/Net, PogoPlug v1/v2, SheevaPlug, and ZyXEL devices.

uBoot verification failed

Postby xandros » Thu May 24, 2012 1:56 pm

Hi,

first time here, first time a have dockstar.
I read http://archlinuxarm.org/platforms/armv5 ... e-dockstar and go into instruction

1. killall hbwd
nothing kill

2.cd /tmp
wget http://jeff.doozan.com/debian/uboot/ins ... ot_mtd0.sh
chmod +x install_uboot_mtd0.sh
./install_uboot_mtd0.sh

is ok everythink

But.....
Unknown uBoot detected on mtd0: 94b18dac843cbc8cb78c787988650bbb

fdisk -l
Disk /dev/mtdblock0 doesn't contain a valid partition table

Disk /dev/mtdblock1: 4 MB, 4194304 bytes

i run with --no-uboot-check

and i get
VERIFICATION FAILED!
## Make a backup of /tmp/uboot-mtd0-dump someplace safe and
## then re-run this installer.

copy ..-dump on usb key

What now?
xandros
 
Posts: 3
Joined: Thu May 24, 2012 1:47 pm

Re: uBoot verification failed

Postby WarheadsSE » Thu May 24, 2012 2:00 pm

That uboot is actually best support @ forum.doozan.com
Core Developer
Remember: Arch Linux ARM is entirely community donation supported!
WarheadsSE
Developer
 
Posts: 6807
Joined: Mon Oct 18, 2010 2:12 pm

Re: uBoot verification failed

Postby xandros » Thu May 24, 2012 2:25 pm

badblocks -nvs /dev/mtdblock0
Checking for bad blocks in non-destructive read-write mode
From block 0 to 1023

Pass completed, 256 bad blocks found. (256/0/0 errors)
xandros
 
Posts: 3
Joined: Thu May 24, 2012 1:47 pm

Re: uBoot verification failed

Postby xandros » Fri May 25, 2012 5:47 am

anyone some advise?
can i reboot, and dockstar work?
if dont, what can i do?
xandros
 
Posts: 3
Joined: Thu May 24, 2012 1:47 pm


Return to Marvell Kirkwood

Who is online

Users browsing this forum: No registered users and 13 guests

cron